| Product Name | 8-Port 10/100/1000Base-T + 4-Port 10G SFP+ L2 Plus Industrial
Managed POE Switch |
| Product Model | LNK-GYM408GXP-SFP |
| Connector Type | 8x 10/100/1000Base-T ports + 4x 10G(1.25/2.5/5G) SFP slots + 1
Console port |
| Network Media | 10BASE-T: Cat3/ 4/ 5 UTP (≤100m) 100BASE-TX: Cat5 or more UTP (≤100m) 1000BASE-TX: Cat5 or more UTP (≤100m) |
| Switching capacity | Capacity in Millions of Packets per Second (mpps) (64-byte packets)
130.94 |
| Bandwidth | 368Gbps |
| Layer 2 Switching | |
| Spanning Tree Protocol (STP) | Standard Spanning Tree 802.1d Rapid Spanning Tree (RSTP) 802.1w |
| G.8032 ERPS | <50ms ring protection for industrial high reliable application |
| Aggregation | Link Aggregation Control Protocol (LACP) IEEE 802.3ad Up to 8 groups Up to 16 ports per group |
| VLAN | Support up to 4K VLANs simultaneously (out of 4096 VLAN IDs) Port-based VLAN 802.1Q tag-based VLAN |
| DHCP Snooping (Layer 2) | Prevent unauthorized configuration and use of IP addresses, while
providing support for IP Source Guard and ARP detection |
| IGMP v1/v2 snooping | IGMP limits bandwidth-intensive multicast traffic to only the
requesters; supports 1024 multicast groups (source-specific
multicasting is not supported) |
| Security | |
| Secure Shell (SSH) Protocol | SSH secures Telnet traffic in or out the switch, SSH v1 and v2 are
supported |
| Secure Sockets Layer (SSL), HTTPS | SSL encrypts the http traffic, allowing advance secure access to
the browser-based management GUI in the switch |
| Port Security | Locks MAC Addresses to ports, and limits the number of learned MAC
addresses |
| IP Source Guard | Prevents datagram with spoofed addresses from being in the network |
| Storm control | Prevents traffic on a LAN from being disrupted by a broadcast,
multicast, or unicast storm on a port |
| ACLs | Support for up to 256 entries; Drop or rate limitation based on
source and destination MAC, VLAN ID or IP address, protocol, port,
differentiated services code point (DSCP) / IP precedence, TCP/ UDP
source and destination ports, 802.1p priority, Ethernet type,
Internet Control Message Protocol (ICMP) packets, IGMP packets, TCP
flag |
| Quality of Service | |
| Hardware | Support 8 hardware queues |
| Scheduling | 8 COS queues per port support strict priority and weighted
round-robin (WRR) |
| Classification | Port based; 802.1p(PCP) VLAN priority based; |
| Rate Limiting | Ingress policer;egress shaping and rate control;per VLAN,per port
and flow based |
| Management (Web/ SSL, Telnet/ SSH, ping, Trivial File Transfer
Protocol (TFTP), SNMP, Syslog) |
| Web GUI interface | Built-in switch configuration utility for browser-based device
configuration (HTTP/ HTTPs). Supports configuration, system
dashboard, maintenance, and monitoring |
| Dual Image | Dual image provides independent primary and secondary OS files for
backup while upgrading |
| Firmware upgrade | Web browser upgrade (HTTP/ HTTPs) and TFTP;Upgrade through console
port as well |
| Port mirroring | Traffic on a port can be mirrored to another port for analysis with
a network analyzer or RMON probe. Up to N-1 (N is Switch’s Ports)
ports can be mirrored to single destination port. A single session
is supported. |
| Other management | Single IP management; HTTP/HTTPs; SSH; RADIUS; DHCP Client; SNTP;
cable diagnostics; ping; syslog; Telnet client (SSH secure support) |
| Green Ethernet | |
| Link detection | Compliant IEEE802.3az Energy Efficient Ethernet Task Force.
Automatically turns off power on Gigabit Ethernet RJ-45 port when detecting link down or Idle of
client. Active mode is resumed without loss of any packets when the
switch detects the link up |
| Cable length detection | Adjusts the signal strength based on the cable length. Reduces the
power consumption for cables shorter. |
| Jumbo frames | Frame sizes up to 9KB supported on Gigabit interfaces |
| MAC Table | Up to 16K MAC addresses. |
| Link Layer Discovery Protocol (LLDP) | Used by network devices for advertising their identities,
capabilities, and neighbors on a IEEE 802 local area network,
principally wired Ethernet. |
| PoE | |
| PoE Standard: | PoE Port Power:30W per PoE port by default, can be customized by
Web management software |
| PoE Ports: | PoE Ports: End-span (Mid-span optional) |
| Minimum Requirements | Web browser: Mozilla Firefox version 2.5 or later, Microsoft
Internet Explorer version 6 or later; Category 5 Ethernet network cable; TCP/IP, network adapter, and network operating system (such as
Microsoft Windows, Linux, or Mac OS X) installed on each computer
in network |
| Dimensions | 165*148*54mm |
| Working Environment | Operating temperature: -40 to 75 ℃; Storage temperature: -40℃ to 75
℃; Operating humidity: 10% to 90% , relative, non-condensing |
| Warranty | 5 years warranty |
